Screwdriver Sentence Examples

We hacked open a can of baked beans with a screwdriver and ate them cold.

I'd better get a screwdriver and tighten that ladder before you fall and break your neck.

The only tool needed to assemble these cabinets is a screwdriver.

Insert the fixture up into the access hole until its lip is even with the ceiling and use a screwdriver to raise the brackets on the inside of the lighting can.

I 'm not completely heartless tho - I bought a screwdriver.

Once you've finished the safety guidelines above, the actual repairs usually require nothing more than a standard screwdriver, wire strippers and sometimes a pair of heavy duty needle nose pliers.

Off to get the T20 torx screwdriver, whatever that is !

Still on the move, he fumbled for his sonic screwdriver.

Use a large flat blade screwdriver to lever the seal out.

Every screwdriver bit you will ever need - we promise !

If it is loose, then use a tiny screwdriver to tighten it.

Second to the Tequila Sunrise is the Screwdriver, made with vodka, orange juice and grenadine, which is enjoyed worldwide.

It was our goal that by using a hammer and screwdriver, we could chisel and opening in the floor above.

To do this you just unscrew two little screws either side with the mini screwdriver provided and unclip a spring.

Off to get the T20 torx screwdriver, whatever that is!

Finally, I bought what I thought was a corded power screwdriver.

What is the the flat-head screwdriver slot on the threaded bolt sticking out of the front of the horn is for?

The nut spinner has a 10mm end to fit rigger nuts with a screwdriver type handle.

Using a screwdriver or similar tool, gently pierce truck bolt holes in the tape from above.

They will be pleased to put a screwdriver or paintbrush in your hand and set you to work !

I ground a notch in the side of an old sturdy flat bladed screwdriver; do n't even bother without it !

You might also need a Phillips head screwdriver.

Use a screwdriver to rotate the the screw to the appropriate DIN number.

Additionally, you will need some general hardware such as nails or screws, a hammer or screwdriver, a level, tape measure and a saw.

All you need are basic tools, such as a hammer, a screwdriver and maybe a pair of pliers.

If your guitar has an opening on the back where you pull the strings through, you will also need a screwdriver to remove the opening's cover.

Some guitars like Stratocasters have a cover over the opening of the backside of the guitar that you will need to remove with a screwdriver to be able to pull the old string through.

You will need a screwdriver to complete the installation.

If there's a decorative faucet cap on the handle, pry it off with a flat head screwdriver.

For this you'll need either a flat or a Philips head screwdriver.

The mechanism itself is relatively straightforward, and some fundamental troubleshooting can be done in a half hour with a screwdriver and possibly a voltage tester.

Use a screwdriver and hammer to tap the bottom sill extender until it is flush with the bottom sill.

Using your screwdriver, unscrew each of the wires and make note of where each color wire is connected.

The only way to get the door back open is to use a knife or screwdriver to pop the pennies back out.

When the victim is away from his or her desk, take a screwdriver or a table knife and pop out two keys from the keyboard and reverse them.

You might even want to take them to an optical repair shop for loose screws, since it's so easy for the screwdriver to slip and scratch a lens.

It contains one metal screwdriver and the two most commonly used hinge screws for frames.

Some screws simply need to be tightened and this can be done with the simple twist of a screwdriver.

Use the tiny screwdriver to tighten the hinges on the side of your glasses.

Use the screwdriver to tighten your glasses bit by bit, and try them on after each adjustment to test the fit.

When planning to repair a pair of Ray-Bans, you may need to order a screwdriver made to fix Ray-Bans.

Use screwdriver to open the car up, then take the key.

The battery pack is inside the palm of the left glove and accessible with a Phillips head screwdriver.

You will need a Phillips head screwdriver to put the batteries in the toy.

The toy is packaged in eight pieces, and a Phillips screwdriver is the only tool needed.

You'll likely need a power screwdriver or drill to complete the installation.

With the jump wire, clip one end to each side of the resistor then clip one wire to the shaft of the screwdriver.

Then clip the wire to one of the terminals and touch the tip of the screwdriver to the opposite terminal.

Some parts will not require any tools for assembly, and most parts will only need a flathead or Phillips screwdriver.

Place the vacuum cleaner upside down and remove the screws will a screwdriver.

This multi-purpose tool can be used to open letters, cut boxes or as a screwdriver.

A hatch case has a notch cut into the back of the case that you can open with a thin screwdriver or even a coin.

Use a flat surface, such as a scraper, wide flathead screwdriver, butter knife, or other tool to gently flake away the rust.

Use the screwdriver to remove all the metal grates from the registers, using a ladder when necessary.

The driver fits easily over the Phillips screwdriver blade.

Using the screws and a drill or screwdriver, attach the hinges at the top and bottom of each panel, in turn attaching each panel to the one next to it.

Once they've determined the proper DIN setting for you, you can often times make minor adjustments yourself using a large screwdriver.

However, before you reach for the screwdriver, consider this.

One arm tightened around her in a light hug, and then he released her, striding away after a screwdriver.

We were alerted only by the feel of the screwdriver's slack penetration.

Some of the smaller gherkins have a tendancy to split when inserting the screwdriver lengthways.

Unplug and remove the existing hard disk with the supplied torx screwdriver (old drive can be kept as an emergency backup ).

The use of threaded mandrel screwdriver tools, as for plain mandrel screwdrivers, is also limited to free running reduced diameter inserts.

It rotates by inserting a screwdriver into the slot in its side.

But to be on the safe, it is still worth carrying a screwdriver in 10 tax free.

Modules are all plug in and only require a screwdriver to remove and replace.

I'm not completely heartless tho - I bought a screwdriver.

They will be pleased to put a screwdriver or paintbrush in your hand and set you to work!

I ground a notch in the side of an old sturdy flat bladed screwdriver; don't even bother without it!

It couldn't be easier with the JCB 6 volt cordless screwdriver.

An electric screwdriver will speed up the assembly process.

I made one out of a flat head screwdriver by grinding a channel in the middle of the bit.

Using your drill with the screwdriver bit, drive the first sheetrock screw at the center of the sheet, and then continue driving the screws every six inches toward the edge of the sheet.

Other than a firm surface upon which to work, you'll only need a pair of small needle-nosed pliers and a small pointed instrument like a watch resizing tool, an ordinary pushpin or a very small screwdriver.