Putty Sentence Examples

She was already putty in his hands.

Most women were putty in the old man's hands, but Claire Quincy had pushed all the wrong buttons and short-circuited his good nature.

Putty contains drying oils which are necessary in order for the compound to remain pliable.

The images were taken using a small magnifying lens in front of the camera lens held in place with putty.

For lime plaster you would normally use lime putty supplied in a tub.

For lime plaster you would normally use lime plaster you would normally use lime putty supplied in a tub.

Does anyone know of an easy way to remove the putty without risking breaking the glass or damaging the existing staining?

The mouth of the mortar was thickened with a ring of modeling putty.

This is the raw material that is used to make lime putty.

I'm now about to try the ' epoxy metal putty ' cure.

Rock material in the mantle exists in a state which acts much like a solid but also flows like silly putty under pressure.

The first step in producing good models or serious conversion is to get hold of some green putty.

Once broken glass has been removed, use a hacking knife to cut away the old putty.

It takes longer to form a skin than linseed oil putty does.

We supply a traditional lime putty based limewash with added linseed oil to improve weather resistance.

If you are involved in a large project it is cheaper to make your own lime putty by slaking quicklime.

Please bring dry pastel, charcoal and compressed charcoal, pencils, eraser, putty rubber, fixative or hairspray.

The bottle rim was again thickened with a ring of epoxy modeling putty.

Do not depend on the putty.

Mixing the Putty Ensure that you mix the putty very thoroughly, or the setting time will increase dramatically.

You can see how the bricks are pointed with a stained mortar and then a line of putty mortar set in.

The surrounding paper can be cleaned with a putty rubber.

Both were putty in the hands of evil men.

Drill at slow speed, applying light pressure and use lubricant, make pool with putty for oil or water.

In the first method I just used putty to build the sandbag wall straight onto its cardboard base.

The longer the slaked lime is matured in the tank the better the lime putty.

The double glazing industry is unanimous in the opinion that one should never use linseed oil putty with dg units.

Mix the shavings with a bit of carpenter's glue, until you have a paste-like consistency, and carefully putty the mix into the furniture until you're happy with the result.

Gently remove the paint with a putty knife, being careful not to gouge the piece of furniture.

Silly Putty - Silly putty is not just for kids.

You may want to use some poster-hanging putty or other tacky item to affix the platters to the serving bowls and the boxes to the table.

The man best known for hocking items like OxiClean, Mighty Putty and Mighty Mend It, died in his sleep in his Florida home.

Use a putty knife or other tool to help you to dig up the root.

Use a wide putty knife as a guard so you don't get paint on the new wall.

You may need to use a putty knife to help loosen it.

Score the paper backing with a stripper, a putty knife, coarse sandpaper, or a razor blade, to make the water soak in easier.

Repair any holes with putty or by patching.

When you've finished nailing the molding into place, take wood putty and fill the visible nail holes.

This putty can also be used to fill small gaps at the joints.

Once the handle is off, use a putty knife to get rid of any caulk around the escutcheon plate and slide the plate off the stem.

Apply another thin layer of joint compound over the tape, smoothing it with the putty knife to create an even finish.

Use the putty knife to create a smooth finish.

After setting each section, use a putty knife to clean up any mortar that has squeezed up between the tiles.

Small drywall repairs, like filling in scratches, small dents or nail holes will require a putty knife, surfacing compound and fine sand paper.

Since the tiles are already in smaller sections, you can start pulling up the corners using a putty knife to loosen them from the floor.

Loosen the tile by using a hammer and a metal putty knife.

Removing the tiles with a putty knife at a 45 degree angle may make them easier to remove.

Use a drywall spatula or a putty knife that has a wide blade.

Lay the fiberglass reinforced paper on top of the mastic and use a large putty knife to smooth out any air bubbles.

Apply a thin coat of thinset mortar to the top of the paper with a large putty knife and allow it to dry.

You can either fill the gap with spray foam insulation or fiberglass insulation using strips of insulation and a putty knife.

Take some plumber's putty and work it with your hands until it becomes soft and pliable.

Apply the putty to the bottom of the Pegasus kitchen sink faucet and set in the holes on the top of the sink.

Clean up any residual plumber's putty that may have squeezed out from underneath the Pegasus kitchen faucet and turn the hot and cold water valves back on.

In sizes 2x to 3x, this coat comes in black or putty.

However, if you don't have the money to spend on these frames, you can attach your posters to inexpensive foam core and then mount them with poster putty or tacks.

You will want to take along scraping or carving tools such as putty knives or plastic utensils.

Whether its silly putty, play dough or slime, these kitchen creations are a lot of fun to make and then to play with later.

Silly putty was a happy accident of chemistry.

Its inventor was trying to make a synthetic rubber and thought that silly putty was an utter failure.

Silly putty is easy to make with borax (which you will find on the laundry aisle at your grocery store) and diluted white glue.

By the time they reached the ground floor, she was putty.

The white and red lead are mixed together to form a putty, and are filled into the socket alternately with layers of well-caulked yarn, starting with yarn and finishing off with the lead mixture.

If parts of the design are to be in relief, they are built up with a putty of black lacquer, white lead, camphor and lamp-black.

Some prefer that the sash-bars should be grooved instead of rebated, and this plan exposes less putty to the action of the weather.

The simple bedding of the glass, without the use of over putty, seems to be widely approved; but the glass may be fixed in a variety of other ways, some of which are.

For example, chips and holes can be filled with wood putty, decaying areas can be treated with fungicides, and traditional waterproofing techniques (such as the use of linseed oil) can be used.