How to use Nozzles in a sentence

nozzles
  • It is driven round by the water pressure of the 2 side komet nozzles, The top komet nozzles have a 10mm diameter outlet.

    0
    0
  • There is a particular focus on motorway service stations with poster advertising on the forecourt, pump nozzles and pos in store.

    0
    0
  • Back pressure and smokebox vacuum could be altered by raising and lower the brass choke positioned between the nozzles.

    0
    0
  • The nozzles of small lamps are inserted in the tubes L, L, for illuminating the webs in a dark field; the light from these lamps is admitted through apertures in the strong hollow cylinder above mentioned (for illumination, see p. 385).

    0
    0
  • So use shut-off nozzles or kink the hose when you 're not spraying.

    0
    0
    Advertisement
  • Spray Arms You may need to check that the water spray arm nozzles are free from blockages.

    0
    0
  • The wingtip pods, which house the reaction control nozzles, were made from plastic card.

    0
    0
  • Check your nozzles, connections and tubing regularly.

    0
    0
  • In another form of the experiment, which, though perhaps less striking to the eye, lends itself better to investigation, the collision takes place between two still unresolved jets issuing horizontally from glass nozzles in communication with reservoirs containing water.

    0
    1
  • These, when reduced to their most simple expression, are mere basin-shaped hollows in the ground, containing ignited charcoal and the substances to be heated, the fire being urged by a blast of air blown in through one or more nozzles from a bellows at or near the top. They are essentially the same as the smith's forge.

    0
    1
    Advertisement
  • The four exhaust nozzles are attached to the engine via four circular cutouts in the fuselage side.

    1
    1
  • Once the heated air leaves the turbines it passes into a bifurcated duct which has a further pair of lateral vectoring nozzles.

    1
    1
  • Watch out for signs of inefficient printing, and then clean the nozzles in the approved way.

    0
    1
  • My trusty 1200 has got black clogged nozzles which I haven't been able to do anything about despite using cleaning cartridges.

    1
    1
  • This type of heater will also shortly be introduced into the hot runner nozzles themselves.

    1
    1
    Advertisement
  • Uncover two new nozzles to gain a dash or rocket ability to explore new areas.

    0
    1