The pistons of the compression and expansion cylinders are connected to the same crankshaft, and the difference between the power expended in compression and that restored in expansion, plus the friction of the machine, is supplied by means of a steam engine coupled to the crankshaft, or by any other source of power.

Internal combustion uses an explosive combustion of gasoline or diesel to operate the piston, cylinder, crankshaft and then the driveshaft of a car.

The first model of this car had issues with the crankshaft position sensor, and the repair required the complete replacement of the crankshaft.

camshaft drive was arranged at the flywheel end of the engine, using a roller chain driven from a sprocket on the crankshaft.

There should be basically no slack in the chain as it runs from the camshaft chainwheel down to the crankshaft chainwheel.

The brake's rotor was coupled to the engine's crankshaft.

As you turn the crankshaft, you will notice the center hole will open up.

ALWAYS use a full race crankshaft with quality bearings.

have the whole crankshaft balanced (the stock factory job was far from good ).

crankshaft driven by a triple chain from the axle.

This Company incorporated certain design modifications of their own, including an underslung crankshaft.

As the piston moves up and down in the cylinder it rotates the crankshaft and converts the straight line motion into rotary motion.

I also made up a new crankshaft from components made by me in the workshop.

Unfortunately, in 1994 the Jacinta also suffered some quite extensive damage to her main engine crankshaft which subsequently put her out of action.

crankshaft pulley, the oil pump sprouts from the block, a necessity to keep the overhead valve gear from seizing up.

crankshaft bearing.

crankshaft position sensor from a car.

crankshaft oil seal was leaking a good bit so I removed the timing cover.

The levers received their motion directly from the engine crankshaft, one being 90 degrees out of phase with the other.

If upgrading to a GP crankshaft high load bearings are required.

MAXIMUM TORQUE AT CRANKSHAFT - 9.88 kgm (97 Nm) at 6,250 r.p.m. fuel injection - Integrated electronic engine management system.

cylinder lagging, trunk guide crankshaft brackets (but not bearing housings ), and flywheel: - maroon.

maged mag flange, twisted crankshaft ).

Above the crankshaft pulley, the oil pump sprouts from the block, a necessity to keep the overhead valve gear from seizing up.

spigot bush in the end of the crankshaft to match the input shaft of the new gearbox.

stator bolts, damaged mag flange, twisted crankshaft ).

underslung crankshaft which substantially reduced its overall weight.

The pistons of the compression and expansion cylinders are connected to the same crankshaft, and the difference between the power expended in compression and that restored in expansion, plus the friction of the machine, is supplied by means of a steam engine coupled to the crankshaft, or by any other source of power.

Remember to use an SD1 spigot bush in the end of the crankshaft to match the input shaft of the new gearbox.

Another major difference was the use of an underslung crankshaft which substantially reduced its overall weight.