The forearms, which are extended, have been cast separately and soldered or brazed on to the elbows.
The Romans used it largely, as it is still used, for the making of water pipes, and soldered these with an alloy of lead and tin.
Mile of Warsaw in 1828, who termed it a "hydrostatic air-pump without cylinders, taps, lids or stoppers," this is attained by using, both for the inlet and the outlet, vertical capillary glass tubes, soldered, the former to somewhere near the bottom, the latter to the top of the vessel.
Thick going through, and soldered into the copper ball Bb.
Upon completion of the sifting, the tea is again fired, and while warm it is packed tightly into lead-lined chests, and the lead covers completely soldered over it, so that it may be kept perfectly air-tight until required for use.
IntheXllthDynastythe soldering of the thin cells for the cloisonnee inlaid pectorals, on to the base plate, is a marvellous piece of delicacy; every cell has to be perfectly true in form, and yet all soldered, apparently simultaneously, as the heat could not be applied to successive portions (M.D.
To make the ligament, a very large number of exceedingly fine copper wires laid close together are soldered to the upper surface of the upper trunnion.
Microscopic accuracy has to be attained in cutting out the space for the insertion of the design, and while the latter must be soldered firmly in its place, not the slightest trace of solder or the least sign of junction must be discernible between the metal of the inserted picture and that of the field in which it is inserted.
Such specimens as have descended to us show that the golden bulla of the middle ages was usually hollow, being formed of two thin plates of metal stamped with the designs of obverse and reverse, soldered together at the edges and padded with wax or plaster.
This structure was formerly regarded as pointing to the fusion of two organs, and the pale was considered by Robert Brown to represent two portions soldered together of a trimerous perianth - whorl, the third portion being the " lower pale."
This is soldered to two thick terminal rods of copper, and the coil is enclosed in a water-tight brass cylinder so that it can be placed in water, or preferably in paraffin oil, and brought to any required temperature.
Long is soldered at either end A, B to thick wires (No.