He stepped into the bright sunlight and withdrew one of hundreds of grey swords housed in small racks along the back side of the dwelling.
Racks of this type usually become impracticable for gradients steeper than 1 in 4, partly because of the excessive weight of the engine required and partly because of the tendency of the cog-wheel to mount the rack.
The wilted tobacco is suspended on racks in the sun.
They are then spread out thinly on trays or racks made of bamboo, canvas or wire netting, under cover, for some 18 or 30 hours (according to the temporary weather conditions) to wither, after which they are in a soft, flaccid condition ready for rolling.
The inking arrangements are usually very good, for, by a system of racks and cogs which may be regulated to a nicety, the necessary distribution of ink and rolling of the printing surface runs in gear with the travelling type bed or coffin.
There are also two vertical racks, one at each end of the casing, in connexion with - the two springs, and these actuate pinions on the axle of the drum and cause it to revolve as the springs extend.
Above the horizontal bar, and parallel with it, is a rod which is connected at its ends with the lower ends of the vertical racks, and at its middle with the horizontal bar.
Overhead hay-racks are unnatural and are liable to drop seeds into a horse's eye.
Cylindrical Wheels and Smooth Racks.In designing cylindrical wheels and smooth racks, and determining their comparati* motion, it is sufficient to consider a section of the pair of pieces made by a plane perpendicular to the axis or axes.
Sliding Contact: Forms of the Teeth of Spur-wheels am Racks.A line of connection of two pieces in sliding contact is line perpendicular to their surfaces at a point where they touch Bearing this in mind, the principle of the comparative motion of pair of teeth belonging to a pair of spur-wheels, or to a spur-whee and a rack, is found by applying the principles stated generally ii 36 and 37 to the case of parallel axes for a pair of spur-wheels, am to the case of an axis perpendicular to the direction of shifting for wheel and a rack.
It also determines the forms of the teeth of straight racks, if one of the centres be removed, and a straight line EIE, parallel to the direction of motion of the rack, and perpendicular to CilCi, be substituted for a pitch-circle.
This cam can be turned by hand in a vertical plane by means of a worm and wheel movement, and by turn - ing the worm the vertical distance between the bar which is attached to the springs and the rod which is attached to the racks can be increased or diminished, and thus the racks can be moved rela - tively to the springs.
Rolling Contact: Smooth Wheels and Racks.In order that two pieces may move in rolling contact, it is necessary that each pair of points in the two pieces which touch each other should at the instant of contact be moving in the same direction with the same velocity.